Boy Struck by Hit-and-Run Van, Crying Mother

1. Play the video and find where you want your clip to start.
2. Click Set In.
3. Keep playing to where you want the clip to end.
4. Click Set Out. The video pauses there so you can see the last frame.
5. Use Jump to In or Jump to Out to go back to either point at any time.
6. Use the Trim buttons to fine-tune the In or Out point by one frame (f) or one second (s).
7. Click Preview range to watch just your selection.
8. Check the clip name, or type your own.
9. Click Add to clip list. Repeat to add more clips from the same video.
10. When your list is ready, click Add clips to cart (or Send clip request). Copy list copies the names and timecodes.

Keyboard shortcuts (with the mouse over the video or this panel, not while typing a name):

• L play; press again for 2x, then 4x (if the video allows)
• K pause
• J step backwards (about 0.1 s at a time; YouTube cannot play in reverse)
• I Set In   O Set Out (pauses on the Out frame)
• Shift+I Jump to In   Shift+O Jump to Out
• ← / → one frame back / forward (moves the In or Out point you just set, otherwise the video)
• Ctrl+← / Ctrl+→ one second back / forward

The price shown here is an estimate. The final price is confirmed in the cart.

Times are shown as timecode: hours:minutes:seconds:frames (for example 00:01:15;12 is 1 minute, 15 seconds and 12 frames). A semicolon before the frames means drop-frame timecode, used for 29.97 fps video.